Runco XP-50DHD Specifications download pdf (Page 61)

Operation

PlasmaWall XP Series Owner’s Operating Manual 49

PRE

IMINAR

HD Format: If the characteristics of the incoming signal on the HD1 or HD2 inputs are

known, select HD Format from the Service menu and set them as described below. Doing

so can reduce the time it takes the DHD Controller to switch from HD to 480i signals or

vice versa.

This is generally not necessary unless the DHD Controller – for whatever reason – has

difficulty determining the color space (RGB or YUV), bandwidth or resolution of the

incoming HD signal. In most situations, the Auto settings work well.

•HD/RGB 1 and HD/RGB 2 (Color Space): Select Auto, RGB or YUV.

• ADC Bandwidth: Select Auto, 75 MHz, 150 MHz or 300 MHz.

• YPbPr Input Resolution: Select Auto or specify the input resolution, if known: 480i,

480p, 576i, 576p, 720p or 1080i.

Triggers: Select Triggers from the Service menu to configure the 12-volt trigger outputs.

You can assign one or more trigger outputs to each aspect ratio. Those triggers are then

activated by selecting that aspect ratio.

To save the trigger settings so that they can be restored after a System Reset (described

below), press

repeatedly to highlight “Save.” Then, press ENTER.

Miscellaneous: Select Miscellaneous from the Service menu to set the following options:

• Language: Select Language from the Miscellaneous menu and press the up- or

down-arrows to select the OSD language. (Currently, only English is supported.)

• Menu Mode: This is the manner in which the OSD menus appear and disappear when

you press MENU. Choose one of the following:

0 = No transition; menus abruptly appear and disappear.

1 = Menus fade in and out.

2 = “Checkerboard” dissolve; menus appear and disappear in sections.

3 = “Window shade” effect; menus are drawn on a diagonal from top left to bottom

right, and retract in the opposite direction.

•Timeout - Short/Long: These settings control how long the OSD menus stay on

screen. Select a time-out period of from 2 to 60 seconds.

• Side Bar Color: This controls the color of the inactive image area. The range is from

-100 (black) to 100 (white).

The inactive image area is on either side of the active image area when using the

Standard 4:3 aspect ratio (or the entire screen when no incoming video signal is

present).

• Film Mode: Enable Film Mode to smooth out moving images from interlaced,

standard-definition (SD) sources. In most cases, the PlasmaWall detects the proper

“pull-down” rate and vertical frequency. However, if your source is jittery and/or tearing

you may wish to enable Film Mode to ensure stable processing for that source.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 79 80

No comments

Runco XP-50DHD Specifications Page 61