Runco PlasmaWall XP-50DHD User Manual download pdf (Page 20)

Controls and Functions

8 PlasmaWall XP Series Owner’s Operating Manual

PRE

IMINAR

1. SLOT 1

Not used.

2. SLOT 2 (DVI-D or Dual HDMI input)

HDCP-compliant digital video input(s). Connect the HDMI output from the DHD

Controller to this input.

If SLOT 2 is equipped with an Dual HDMI input board, connect the HDMI output

from the DHD Controller to input “A” on this board.

If SLOT 2 is equipped with a DVI-D input board, the audio input is not used. Connect

the audio outputs from your sources to an external audio receiver.)

3. SLOT 3

Not used.

4. PC IN

Not used.

5. RS-232C (9-pin, male D-Sub)

Connect the RS-232 OUT port on the DHD Controller to this input.

6. POWER INPUT

Connect the PlasmaWall to AC power here.

2.2

DHD Controller Front

Panel

Figure 2-5 shows the controls and indicators on the DHD Controller front panel; the

paragraphs that follow describe them.

Figure 2-5. DHD Controller Front Panel

1. RUNCO ICON

Lights red to indicate that the DHD Controller is in standby mode; lights blue to

indicate that the unit is on.

2. POWER BUTTON

Press once to toggle from standby mode to on mode. Press it again to return to

standby mode. For a discrete on or off command, you can use the direct access

buttons on the remote control.

3. IR SENSOR

Receives IR commands from the remote.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 79 80

No comments

Runco PlasmaWall XP-50DHD User Manual Page 20