Runco VX-60d Specifications download pdf (Page 41)

Installation

Signature Cinema™ SC-50d/SC-60d Installation/Operation Manual 25

PRE

IMINAR

3.4

Installing the Primary

Projection Lens

The projection lens is shipped separately from the projector. Proceed as follows to install

it:

1. Remove the lens plug from the lens opening in the projector.

2. Remove the rear cap from the lens. (Keep the front lens cap on the projection lens to

protect it from damage during the installation process.)

3. Rotate the lens clamp to the OPEN position.

4. Remove and retain the two security screws from the

lens mount.

5. Align the lens interface plate with the lens mount. Align the lens electrical connector

with the mating connector on the lens mount. Fully insert the assembly straight into

the lens mount opening without turning. Press using your hand.

6. While holding the lens flat against the lens mount, rotate the lens clamp clockwise to

lock the lens assembly in place.

7. Re-attach the lens mount security screws that you removed in Step 4.

8. Remove the front lens cap.

Never operate this projector without a lens. The lens seals the

projector, preventing contaminants from entering the interior of the

projector.

When installing the lens, ensure that it is not inserted at an angle, as

this can cause damage.

WARNING

CLAMP CLOSED

MOUNTS

CLAMP OPEN

SECURITY

SCREW

SECURITY

SCREW

Security

Screws

Note

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 125 126

No comments

Runco VX-60d Specifications Page 41