Runco CW-61 Installation Manual download pdf (Page 23)

Runco CinemaWall Owner’s Operating Manual 13

PRE

IMINAR

3.1

Remote Control

To install batteries in the remote control:

1. Remove the battery cover from the back of the remote control.

2. Insert the batteries included with the remote control. Ensure that the polarities

correctly match the

and markings inside the battery compartment.

3. Replace the battery cover.

If you have a CW-61 remote: After a few seconds, the remote starts up automatically and

an Introduction screen appears. The remote control beeps twice to indicate that it has started

up successfully.

Notes on Batteries• When installing batteries, make sure that the battery polarities are correct.

• Do not mix an old battery with a new one or different types of batteries.

• If you will not use the remote control for a long time, remove the batteries to avoid

damage from battery leakage.

Notes on Remote Control

Operation

The remote control can be used to control the CinemaWall within the ranges shown in

Figure 3-1.

Figure 3-1. Available Range of the Remote Control

3. Installation

Approx.

7m/23ft

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 65 66

No comments

Runco CW-61 Installation Manual Page 23