Runco CW-61 Installation Manual download pdf (Page 33)

Runco CinemaWall Owner’s Operating Manual 23

PRE

IMINAR

4.1

Turning on the Power

1. Turn on your source components.

2. Attach the two ferrite cores supplied with the display to each end of the AC power

cable as shown in

Figure 4-1. Doing so will reduce radio frequency interference (RFI)

emissions to a level that conforms to FCC regulations. Use the supplied plastic bands

to secure the cores in place.

Figure 4-1. Attaching the Ferrite Cores to the Power Cable

3. Plug the female end of the power cord into the AC receptacle on the rear of the

CinemaWall (AC 100V ~ 240V). Connect the other end to your AC power source.

4. Press the POWER button on the underside of the CinemaWall. The power indicator

lights solid green.

5. After a brief warm-up period (approximately 10 seconds), the CinemaWall will display

an image.

4.2

Changing the OSD

Language

The CinemaWall OSD language is initially set to English, but can also display the menus in

German (Deutsch), French (Français), Spanish (Español) or Italian (Italiano). To change the

OSD language:

1. Press OK or MENU.

2. Select Install from the Main Menu.

3. Select Language from the Install Menu.

4. Press right- or left-arrow button ( or ) to highlight the desired language and press

OK or MENU. The change takes effect immediately.

4. Operation

Power cable

Ferrite Core

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 65 66

No comments

Runco CW-61 Installation Manual Page 33