Runco CW-61 User Manual download pdf (Page 9)

HOW TO ATTACH OPTIONS TO THE PLASMA MONITOR

You can attach your optional mounts or stand to the plasma monitor in one of the following two ways:

1) While it is upright. (See drawing A)

2) As it is laid down with the screen face down (See drawing B). Lay the protective sheet, which was wrapped

around the plasma monitor when it was packaged, beneath the screen surface so it does not scratch the screen

face.

* DO NOT touch or hold the screen face when carrying the unit.

• This device cannot be installed on its own. Be sure to use a stand or original mounting unit. (wallmount unit,

stand, etc.)

• For correct installation and mounting, it is required to use a trained, Runco Authorized Dealer. Failure to follow

correct mounting procedures could result in damage to the equipment or injury to the installer. Product warranty

does not cover damage caused by improper installation.

Use only the mounting kit or stand provided by Runco. Refer to mounting kit for detailed instructions.

(2")

(2") 50

(2")

Wall

(2")

Ventilation Requirements for enclosure mounting

To allow heat to disperse, leave space between surrounding

objects as shown on the diagram to the right when installing.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 69 70

No comments

Runco CW-61 User Manual Page 9