Runco CW-42HD User Manual download pdf (Page 26)

Installation

16 Runco CinemaWall Owner’s Operating Manual

PRE

IMINAR

3.3

Installation

Considerations

Proper installation of your CinemaWall will ensure the highest possible picture quality.

Whether you are installing the CinemaWall temporarily or permanently, you should take

the following into account to ensure that it performs optimally.

Mounting the CinemaWall

on a Wall or

Table Stand

To install the CinemaWall, you will need either an optional table stand or wall-mounting kit.

The CinemaWall cannot be installed on its own.

If you do decide to wall-mount the CinemaWall, ensure that the wall-mount bracket is

installed according to the instructions included with it. The wall must be capable of

supporting a redundant weight factor three (3) times the weight of the display, or be

reinforced.

Runco recommends that this be done by a custom installation specialist.

You can attach your optional mounts or stand to the CinemaWall in either of two ways:

• While it is upright.

• As it lies flat with the screen face

down. Place the protective sheet,

which was wrapped around the

plasma monitor when it was

packaged, between the screen and

your work surface to avoid

scratching or otherwise damaging

the screen surface.

Ambient Light In general, minimize or eliminate light sources directed at the display. Contrast ratio in your

images will be noticeably reduced if light directly strikes the display, such as when a shaft

of light from a window or floodlight falls on the image. Images may then appear washed

out and less vibrant.

➤

Use only a Runco-approved wall-mount kit or table stand that is

specifically designed for your display.

Note

➤

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 65 66

No comments

Runco CW-42HD User Manual Page 26