Runco Q-650i Series Owner's Manual download pdf (Page 14)

2625

Universal Remote Control, Inc. The Omega

Erasing the Entire Omega

To erase EVERYTHING, press and hold both the MAIN and the STOP

buttons for 15 seconds. After 15 seconds, the RESET screen appears.

Press the SURE button to erase all of your settings and return to the fac-

tory default setup.

ALL Button

erases all

settings.

PROG Button

erases three digit

codes, Page, Text

and Punch

Through settings.

Cloning One Omega to Another

If you own two or more Omega, you can copy and transfer all the setup

from one Omega to another. Just follow these easy steps:

Enter SETUP mode by pressing and holding both MAIN and ENT

for three seconds.

Note: You have 30 seconds for each step, otherwise the Omega will time

out automatically.

Press the CLONE button.

Align the two Omega head-to-head, about an inch apart.

Press the RECV display button on the new Omega you would like

to setup by cloning.

Press the SEND display button on the Omega you previously setup.

Press the START button on the new Omega and then press the

START button on the Omega you previously setup.

Note: Cloning typically takes about 40 seconds.

After completion, the cloned Omega will flash “GOOD”.

Return to normal operation by pressing the MAIN button twice.

Erasing

You can erase an individual button with a learned command, a macro

or a favorite channel. You can erase an entire Device’s learned com-

mand or macro buttons. You can also erase ALL your learned com-

mands on all devices or all your macros or favorite channels every-

where. If you really want a fresh start, it is possible to reset everything to

the factory default condition.

Erasing Learned Buttons, Macros or Favs

Enter SETUP mode by pressing and holding both MAIN and ENT

for three seconds.

Note: You have 30 seconds for each step, otherwise the Omega will time

out automatically.

Press the ERASE button.

Press either the LEARN, MACRO or FAV button.

The following screen appears:

If you press ALL, the Omega displays a SURE? button. After the

SURE button is pressed, all the buttons will be erased.

If you press DEVICE, a list of Devices will appear. Press the

device button that you wish to erase. The bottom of the screen

will flash ERASE twice, then ERASED.

If you press KEY, you’ll have to navigate to the Device and Page

you want using the MAIN, DEVICE and PAGE buttons. Press a

button to erase it. The bottom of the display will flash ERASE

twice, then ERASED.

To return to normal operating mode, press the MAIN button four

times.

ALL —

DEVICE—

KEY—

OCE-0031B Rev05_130x220 2007.5.14 9:55 AM 페이지25

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 31 32

Comments to this Manuals

No comments

Runco Q-650i Series Owner's Manual Page 14

Comments to this Manuals

Related products and manuals for Projectors Runco Q-650i Series