Runco Q-650i Series Owner's Manual download pdf (Page 17)

3231

Universal Remote Control, Inc.

From the RF Settings Menu, select IR/RF.

Decide whether you are changing the Signal for all devices or just

one of the devices of the Omega.

Select ALL to change the signal settings to

ALL devices in the Omega. Then, go to Step

Select DEVIC to change the signal settings to

just one of the devices in the Omega. Then,

go to Step 3.

The display changes to a list of the names of your devices. If you have

two pages of devices, pressing either of the page buttons will display

the other page. Select the device you would like to change IR/RF set-

tings, then go to Step 4.

Select the new setting by pressing the desired button, then press SAVE

to save your new setting and return to the RF settings menu.

The Omega

Change IR from ON to OFF.

Change RF from ON to OFF.

Save the new setting

Select a device

Page Button

displays the

other page

of devices.

Exit this Menu without changing

the IR/RF settings

Press the RF button.

The RF Settings Menu appears. See the notes on the following

pages for more info on each option. Make your selection by press-

ing the button you want:

After you’ve made a new setting and SAVED your change, use the

EXIT button to return to the Setup menu. Use the MAIN button to

return to normal operation.

IR/RF Signal Setting

You can set the signal to be IR line-of-sight only, RF only or IR and RF

simultaneously. Additionally, you can set the signal the same way for ALL

ten of your devices OR you can set the signal differently for each device

(the plasma TV could be set to be IR line-of-sight only, while the DVD

player and the Satellite receiver are set to be RF only). A good reason to set

the signal to RF only is to prevent too much IR being sent to a sensitive

component from two arrivals at the front panel (one directly from the

Omega, one from the RF base station). A good reason to set the signal to

IR only is that another room has an MRF-100 base station (no RF address)

so it will receive commands from the Omega unless it is set to IR only.

RF Button

Signal (IR,

RF or Both)

Base Station

ID #

Emitters - ALL

or a specific

Emitter

Blaster - Turn

the Blaster

On or Off

Exit this Menu

OCE-0031B Rev05_130x220 2007.5.14 9:55 AM 페이지31

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 31 32

Comments to this Manuals

No comments

Runco Q-650i Series Owner's Manual Page 17

Comments to this Manuals

Related products and manuals for Projectors Runco Q-650i Series