Runco Q-650i Series Owner's Manual download pdf (Page 19)

3635

Universal Remote Control, Inc.

From the RF Settings Menu, select BLAST.

Decide whether you are changing the Blaster for all devices or just

one of the devices of the Omega.

Select ALL to change the blaster settings to

ALL devices in the Omega. Then, go to Step

Select DEVIC to change the blaster settings to

just one of the devices in the Omega. Then,

go to Step 3.

The display changes to a list of the names of your devices. If you have

two pages of devices, pressing either of the page buttons will display

the other page. Select the device you would like to change IR/RF set-

tings, then go to Step 4.

Select the new setting by pressing the desired button, then press SAVE

to save your new setting and return to the RF settings menu.

The Omega

Select a device

Page Button

displays the

other page

of devices.

Changes the cur-

rent front panel

BLASTER setting

Save the new setting

Exit this Menu with-

out changing the

EMITT settings

The display changes to a list of the names of your devices. If you have

two pages of devices, pressing either of the page buttons will display

the other page. Select the device you would like to change the

Emitter settings, then go to Step 4.

Select the new setting by pressing the desired button, then press

SAVE to save your new setting and return to the RF settings menu.

BLAST - Setting the Front Panel Blaster On or Off

The MRF-250 and MRF-300 Base Stations have a configurable

front panel high power IR LED or “blaster” for controlling compo-

nents in the same cabinet space without emitters attached to their

front panel. The front panel blaster can overpower or saturate the

sensors of some A/V components, so if intermittent operation

occurs, the blaster should be turned off.

The blaster is incompatible with a stack of identical components,

since all components will receive IR commands at once, no mat-

ter what device is selected. Turn off the front panel blaster by fol-

lowing the steps described on the next page:

Change the IR

line output

using UP and

DOWN buttons

Displays the

current IR line

output

Save the new setting

Exit this Menu with-

out changing the

EMITT settings

Select a device

Page Button

displays the

other page

of devices.

OCE-0031B Rev05_130x220 2007.5.14 9:55 AM 페이지35

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 31 32

Comments to this Manuals

No comments

Runco Q-650i Series Owner's Manual Page 19

Comments to this Manuals

Related products and manuals for Projectors Runco Q-650i Series