Runco VX-44D User Manual download pdf (Page 56)

Installation

40 Runco VX-44d/-55d Installation/Operation Manual

PRE

IMINAR

3.8

Turning on the Power

1. Turn on your source components.

2. Turn on the main power switch at the rear of the DHD Controller.

3. If this is an AutoScope-equipped projector, turn on the main power switch at the rear

of the AutoScope lens motor. The lens motor power switch is located next to the AC

input (see Figure 3-16).

4. Press the ON button on the remote control – or the POWER button on the DHD

Controller front panel – to turn on the system. The vacuum fluorescent display on the

DHD Controller front panel briefly displays “Initializing System,” followed by “Starting

VX-44d/-55d.”

The LED status window at the rear of the projector displays an active pattern of

segments to indicate that it is changing its state from “standby” to “on.”

5. When the projector has completed its initialization and is ready

for use, “On” appears in the projector LED status window.

The fluorescent display on the DHD Controller indicates the active source, input

resolution/frame rate and aspect ratio; for example:

VX-44d HDMI 1

16:9 1080i/60

Current

Source

Aspect Ratio

Input Resolution/Frame Rate

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 119 120

No comments

Runco VX-44D User Manual Page 56