Runco VX-1000d Specifications download pdf (Page 18)

Controls and Functions

6 Runco VX-2000d Owner’s Operating Manual

PRE

IMINAR

1. VERTICAL LENS SHIFT

Using a 9/64” hex wrench, turn this to move the lens up or down.

2. POWER LED

Lights red to indicate that the projector is in standby; flashes blue during warm-up or

cool-down or lights blue to indicate normal operation.

3. TEMP LED

Lights red to indicate that the projector has overheated and shut down.

4. INTAKE VENTS

Cool air enters the projector through these vents. To prevent overheating, ensure that

these vents are never blocked.

5. LAMP LED

Lights blue to indicate normal lamp operation; lights red if the lamp has failed.

6. EXHAUST VENTS

Hot air exits the projector through these vents. This air can be quite hot. Ensure that

there are no heat-sensitive objects near it and that it is never blocked.

7. ZOOM TAB

Turn this tab to make the projected image larger or smaller.

8. FOCUS RING

Turn this ring to focus the image.

9. RUNCO LOGO

You can rotate the logo to match the projector orientation: inverted (ceiling-mounted)

or upright. To rotate the logo, grip it at the sides, pull it away from the projector and

rotate it 180 degrees.

10. CABLE OPENING

Pass cables through this opening.

11. LAMP COVER

Remove this cover to access the lamp compartment.

12. REAR PANEL ACCESS DOOR

Open this door to access the rear-panel connectors and built-in keypad. To open the

door, push on the left side of the lever and rotate it 90 degrees clockwise. Then, pull

the lever toward you and down slightly.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 89 90

No comments

Runco VX-1000d Specifications Page 18