Runco Q-650i Series Owner's Manual download pdf (Page 7)

Universal Remote Control, Inc. The Omega

Volume Control Punch Through

In most home entertainment systems, the sound volume is only con-

trolled by one device. In some systems, it is the TV speakers that make

the sound, so you would use the TV device on the Omega to raise and

lower the volume. In another system, it might be a surround sound

receiver and speakers that control the sound, so you would use the

Omega’s AUDIO device to adjust the volume. Constantly switching the

Omega to TV or AUDIO to adjust the volume is inconvenient in daily

life.

You can use Punch Through to set the Omega’s volume buttons to

always control the sound in your system. That way when the Omega is

set to VCR or DVD, the volume up, down and mute buttons will work

perfectly without switching back to AUDIO or TV. Here’s how:

Enter Setup mode by pressing and holding both MAIN and ENT for

three seconds. The top of the display show you are in SETUP mode

now.

Note: You have 30 seconds for each step, otherwise the Omega will time

out automatically.

Press the PUNCH button.

Press the VOL button. The display confirms by displaying “VOL” at the

top of the screen. This sets up the group of three buttons (Volume Up,

Volume Down and Mute) in one action!

The bottom of the display flashes ”PUNCH TO”.

Select the

Transport group

(Play, Pause,

Stop, Rew, FFwd)

Select the VOL-

UME group (Vol

Up, Down & Mute)

Select the

CHANNEL group

(Channel Up,

Channel Down

and PREV CH)

Select the POWER group

(ON and OFF)

Select the MENU

group (Menu, Guide,

Info, Exit, Up, Down,

Left, Right, Sel)

Press and hold the button you want on your old remote control until

the display changes to either “GOOD” or “FAILED”.

If the “GOOD” label appears on top of the display, you were successful.

Now, press the next button you wish to teach. Keep repeating steps 6

through 7 until you have learned all the buttons you want.

If the “FAILED” label appears on top of the display, try to teach the

same button in Omega once again by repeating steps 6-7.

Continue to teach any commands from any of your remote controls

by repeating steps 5-7 (to go back to step five, press MAIN once).

Once you completed teaching all the buttons, return to normal opera-

tion by pressing the MAIN button twice. Test all your new commands.

If any of them don’t work, try learning again using these notes:

Move to another room. Plasma TVs, sunlight, halogen or

quartz lighting can interfere with the learning process.

Although the old remote control seems to work fine,

change the batteries to fresh alkaline batteries.

Vary the distance between the remote controls

gradually. Try 1/4”, 1”, 2”and so on, up to 4 feet.

Tap the button on the original remote control instead of

pressing and holding it during the learning process.

OCE-0031B Rev05_130x220 2007.5.14 9:55 AM 페이지11

1 2 3 4 5 6 7 8 9 10 11 12 ... 31 32

Comments to this Manuals

No comments

Runco Q-650i Series Owner's Manual Page 7

Comments to this Manuals

Related products and manuals for Projectors Runco Q-650i Series