Runco Q-650i Series Owner's Manual download pdf (Page 18)

3433

Universal Remote Control, Inc.

EMITT - Setting IR Emitter Outputs

The MRF-250 and MRF-300 Base Stations enable you to route or

steer the IR commands from any Device to any or all of the IR

Line Outputs. This allows you to control identical devices using

the exact same IR commands (such as an array of television sets

in a media room or a stack of identical satellite receivers installed

in a central location with one satellite receiver dedicated to each

room with a television). Each button push (or macro step) is rout-

ed to the specific IR Line Output you’ve assigned to a device. In

the factory set default settings, the Omega is set to route IR com-

mands from any device to ALL IR Line Outputs simultaneously. To

change the Omega default settings follow these steps:

From the RF Settings Menu, select EMITT.

Decide whether you are changing the Emitter settings for all devices

or just one of the devices of the Omega.

Select ALL to change the Emitter settings to

ALL devices in the Omega. Then, go to Step

Select DEVIC to change the Emitter settings

to just one of the devices in the Omega.

Then, go to Step 3.

The Omega

Select the new setting by pressing the desired button, then press SAVE

to save your new setting and return to the RF settings menu.

Change ID#

using UP and

DOWN buttons

Displays the

current ID#

Save the new setting

Exit this Menu with-

out changing the

IR/RF settings

ID # - Setting Base Station Address

When you are installing a system within 100 feet of another equipment

location in the same home OR near a home, condo, yacht or motor

home that might potentially have an RF remote control of any kind, it is

recommended that you use an addressable base station and set the

address as described here.

You can operate up to 15 different equipment locations, each with an

MRF-250 or MRF-300 assigned a unique Receiver ID#. You program

each or all of your Omega devices to the appropriate equipment loca-

tion by assigning the corresponding ID# in the RF Settings Menus.

From the RF Settings Menu, select ID#.

Decide whether you are changing the ID# for all devices or just one

of the devices of the Omega.

Select ALL to change the ID# for ALL devices

in the Omega. Then, go to Step 4.

Select DEVIC to change the ID# for just one

of the devices in the Omega. Then, go to Step

The display changes to a list of the names of your devices. If you have

two pages of devices, pressing either of the page buttons will display

the other page. Select the device you would like to change the ID#,

then go to Step 4.

Select a device

Page Button

displays the

other page

of devices.

OCE-0031B Rev05_130x220 2007.5.14 9:55 AM 페이지33

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 31 32

Comments to this Manuals

No comments

Runco Q-650i Series Owner's Manual Page 18

Comments to this Manuals

Related products and manuals for Projectors Runco Q-650i Series