Installation
42 Q-750d Ultra Series Installation/Operation Manual
PRE
L
IMINAR
Y
Ethernet Network Connection: Use a standard, Category 5 network cable with an
RJ-45 plug to connect a network hub, router or gateway to the Ethernet port on the DHD
Controller; see Figure 3-21. For more information about configuring and using this
connection, refer to Network on page 76.
Figure 3-21. Ethernet Network Connection to DHD Controller
Connecting to AC Power Projector/DHD Controller: Plug the female end of one power cord into the AC
receptacle on the rear of the Q-750d Ultra (AC 100V ~ 240V). Then, connect the other
end to your AC power source.
Similarly connect the DHD Controller to a nearby AC outlet.
AutoScope Lens Motor: With AutoScope-equipped projectors, an additional power
cord is provided for the lens motor. Plug the female end of the AC power cord into the AC
input on the rear of the lens motor assembly. Connect the other end to your AC power
source.
To Accessory Box
IR
Display Control
HDMI 3
HDMI 4
Ethernet
HDMI Out
To Display
HDMI Out
Audio Only
RS-232
T
ccessor
B
x
HDMI
HDMI Out
Dis
l
DMI
-23
1
8
to Ethernet
Hub, Router
or Gateway
1 Transmit Data +
2 Transmit Data -
3 Receive Data +
6 Receive Data -
Comments to this Manuals