Runco Q-750d Ultra Series Specifications download pdf (Page 76)

Operation

60 Q-750d Ultra Series Installation/Operation Manual

PRE

IMINAR

Contrast: On your external test pattern source, select a stepped, gray-bar pattern like the

one shown in Figure 4-3.

Figure 4-3. Typical Gray Bar Pattern for Adjusting Contrast

Select Contrast and press ENTER. Adjust the contrast to a point just below which the

white rectangle starts to increase in size.

Color Saturation: On your external test pattern source, select a color bar pattern like the

one shown in Figure 4-4.

Figure 4-4. Typical Color Bar Pattern for Adjusting Color Saturation and Tint

1. Press the MENU button on the remote control or DHD Controller front panel.

2. Select Service from the Main Menu and press ENTER.

3. Enter the Service menu passcode.

4. Select Display Device from the Service menu and press ENTER.

5. Press ENTER again to select Configure.

Brightness and contrast controls are interactive. A change to one

may require a subtle change to the other in order to achieve the

optimum setting.

Note

gray

yellow

cyan

green

magenta

red

blue

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 133 134

No comments

Runco Q-750d Ultra Series Specifications Page 76