Runco Q-750d Ultra Series Specifications download pdf (Page 98)

Operation

82 Q-750d Ultra Series Installation/Operation Manual

PRE

IMINAR

Front Panel Brightness: Select Front Panel Brightness from the Service menu to adjust

the brightness of the front-panel LED and LCD status indicators.

• Logo LED: Select Logo LED from the Front Panel Brightness menu to adjust the

brightness of the large, illuminated logo on the left side of the display. The range is from

0 (off) to 31.

• Standby LED: Select Standby LED from the Front Panel Brightness menu to change

the behavior of the front-panel STANDBY indicator LED. When set to ON, the LED

lights amber when the system is in standby mode; otherwise, it is off. When set to OFF,

the LED is always off.

•LCD: Select LCD from the Front Panel Brightness menu to adjust the brightness of the

front-panel LCD. The range is from 0 (off) to 4.

Auto Power Off: Select Auto Power Off from the Service menu to have the Q-750d Ultra

turn itself off after a period of inactivity (no source signal present).

•Enable: By default, Auto Power Off is disabled. To enable it, select Enable from the

Auto Power Off sub-menu and set it to On.

•Hours: The default time-out period is eight (8) hours; the range is from 1 to 24 hours.

During a firmware upgrade, this LED lights at full brightness

regardless of the Logo LED setting.

During a firmware upgrade, this LED lights at full brightness

regardless of the Standby LED setting.

Logo LED

LCD

Standby LED

Note

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 133 134

No comments

Runco Q-750d Ultra Series Specifications Page 98