Runco Q-750d Ultra Series Specifications download pdf (Page 104)

External Control

88 Q-750d Ultra Series Installation/Operation Manual

PRE

IMINAR

• y is the operand, which can have one of the following values:

? = “Get” operand + = “Increment” operand

= = “Set” operand - = “Decrement” operand

• z is the value to set for this parameter. It can have one of two formats:

• Integer value: Any positive or negative number; for example, 100.

• String value: Any string surrounded by double quotes; for example, “This is a

string.”

• [CR] is the ASCII carriage return key (0x0D).

Response Format Responses sent from the follower to the initiator shall have the following format:

(u;www:x=z) [CR]

Where:

• ( and ) indicate the start and end of the command data. If these characters are

present, the DHD Controller assumes that valid command data is present in the

command string. Otherwise, the DHD Controller ignores the command.

• “u;” indicates the response code. This is only used by followers responding to a valid

CLI command received. For any response code other than 0, the follower echoes back

the command received rather than filling in the fields listed below.

The response code can be one of the following:

• 0 = Command successfully processed

• 1 = Unknown command code

• 2 = Invalid operator

• 3 = Destination parameter not supported

• 4 = Setting not available

• 5 = Setting value not available

• 6 = Setting value not supported

• 7 = String too long

• 8 = Command not supported in standby mode

• 9 = Invalid parameter

• 10 = Error processing command

• 11 = Password not entered

• www indicates the command code. This field is case insensitive; for example, PWR, pwr

and PwR are all equivalent.

• :x is the destination parameter. This is an optional parameter that indicates which

memory the command is referencing. This parameter is reserved for future use.

• z is the new value (for Set, Increment or Decrement commands) or the current value

(for Get commands) for this parameter. It can have one of two formats:

• Integer value: Any positive or negative number; for example, 100.

• String value: Any string surrounded by double quotes; for example, “This is a

string.”

• [CR] is the ASCII carriage return key (0x0D).

➤

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 133 134

Comments to this Manuals

No comments

Runco Q-750d Ultra Series Specifications Page 104

Comments to this Manuals

Related products and manuals for Data projectors Runco Q-750d Ultra Series